Glossary entry (derived from question below)
English term or phrase:
abrasive formation
Italian translation:
Formazione abrasiva
May 4, 2009 07:54
15 yrs ago
English term
abrasive formation
GBK
English to Italian
Science
Mining & Minerals / Gems
Definition from
Hacettepe University:
A rock consisting of small, hard, sharp-cornered, angular fragments, or a rock, the cuttings from which, produced by the action of a drill bit, are hard, sharp-cornered, angular grains, which grind away or abrade the metal on bits and drill-stem equipment at a rapid rate.
Example sentences:
Coiled tubing drilling was selected due to the small production casing and the aggressive curve section buildup rate in the hard, abrasive formation. (Hart Energy Publishing, LP )
In general, an impregnated diamond bit with a low identifying number such as “D2” would be used to drill a relatively soft, fractured and abrasive formation. (Dimatec Inc)
If used in the correct rock type then the drilling speed is faster than with other bits designs. These bits can't be used in soft and high abrasive formation rocks. (Rod Pietsch)
Proposed translations
(Italian)
| 4 +2 | Formazione abrasiva |
pcs_MCIL
|
Change log
May 3, 2009 12:58: changed "Kudoz queue" from "In queue" to "Public"
May 4, 2009 07:54: changed "Stage" from "Preparation" to "Submission"
May 7, 2009 08:54: changed "Stage" from "Submission" to "Selection"
Jun 3, 2009 13:54: changed "Stage" from "Selection" to "Completion"
Proposed translations
+2
15 hrs
Selected
Formazione abrasiva
Definition from
Webster's Online Dictionary:
A rock consisting of small, hard, sharp-cornered, angular fragments, or a rock, the cuttings from which, produced by the action of a drill bit, are hard, sharp-cornered, angular grains, which grind away or abrade the metal on bits and drill-stem equipment at a rapid rate. Syn:abrasive ground
Example sentences:
A denti corti e fitti con riporti in carburo di tungsteno, adatti per formazioni dure e abrasive quali arenarie, solomie, calcari duri e graniti. (ES Italy)
I disegni impregnati espongono continuamente un filo di lama tagliente e sono progettati dal trivello semiduro al più duro, alla maggior parte delle formazioni abrasive a vari RPM, compreso i rotos, PDMs e le turbine. (Alibaba)
4 KudoZ points awarded for this answer.
Something went wrong...